Garage door sensors utilize a photo eye sensor and a beam of infrared light that goes between the two units.
How to bypass photo eyes on garage door.
The units are placed near the ground on either side of the garage door.
As you know it is a safety device so the garage does not crush you car your kid or your dog.
The garage door will continue to close if your steps avoid the photo eye sensor.
If done correctly you ll have disconnected your safety sensors from your garage door.
Since most photo eye sensors are placed at that two inch height most people know you can simply step high above the infrared light to bypass the system.
The safest way to bypass a garage door sensor is to disconnect the.
Pull the emergency release cord to disconnect the garage door from the opener.
Disconnecting the garage door opener from the garage door will bypass the sensors.
How to bypass a garage door sensor.
Cut the wires about 1 inch 2 5 cm from the safety sensor.
If the photo eye senses an obstruction it stops the door from closing and potentially prevents damage or injury to a vehicle.
Final takeaway bypass garage door sensors.
The photo eye of an automatic opening garage door is a safety feature.
We hope you find this comprehensive guide on how to bypass the garage door sensors helpful.
And if you are planning to upgrade to a new garage door or sensors make sure to check out a few available options in the.
The units are placed near the ground on either side of the garage door.
The emergency release cord.
Press the garage door opener wall button to fully open the garage door.
The easy way to do it is to re route the eyes above the garage or off to the side.
Use a pair of wire cutters to cut the white and black wire about an inch from the sensor.