Be sure to wrap all corners overlapping the metal lath at lease 4.
How to attach lath to concrete wall.
Measure and cut the wire mesh to the desired dimension.
Using nailpro ct3040 air pin concrete tool huge labor savings using 1 1 4 metal stucco washers 3 4 pins only 100 psi so much faster than any powder actua.
Stucco thickness on cinder block concrete block or cmu walls add more stucco if not sure its thick duration.
Including cleaned and untreated concrete masonry or stucco.
Kirk giordano plastering inc.
Stop the metal lath 1 from finished edges.
If you are applying stone veneer to a painted or sealed concrete foundation attach a layer of metal lath to the concrete wall with masonry anchors.
Hold the wire mesh in the desired position.
If paper backing behind the lath is required leave the paper over hanging at the top and to the left of the sheet.
Begin at the right hand bottom corner of the wall.
Draw around the outside edge of the wire mesh with plumber s.
For attaching something relatively light to concrete it s hard to beat the speed and ease of hammer set anchors.
Then wash the surface with.
How to fasten lath to concrete walls step 1.
Wire mesh is available i 28 to 36 inch widths with roll measurements from 50 to 100.
How to attach wire mesh to block walls.
Cover the lath with a scratch coat of mortar to.
Each anchor consists of an unthreaded pin set into a metal sleeve.