Tapcon 2 3 4 in x 1 4 in concrete anchors.
How to anchor a half wall on concrete.
Screwed directly into the block for a finished look if using a stud type anchor female type anchor or the concrete screw the fixture or item being fastened can be removed at any time with little or.
Drill the hole at least 1 4 inch deeper than the length of the lower portion and vacuum or blow out the hole.
It should be a fairly tight fit.
The anchors hold the bottom plate very securely and greatly reduced the movement of the wall but i also needed some extra bracing to keep the studs from moving back and forth on the bottom plate.
Continue to hammer the anchor down until the nut and washer are tight against the fixture.
A hammer drive anchor requires only a small pilot hole.
Drop the anchor into the hole in your fixture and hammer the pin on the top of the anchor to drive it into the concrete hole you drilled earlier.
Place the two by four in its desired location.
Machine screw anchor lag shield anchor single expansion anchor double expansion anchor leadwood screw anchor 4 concrete screw.
I nailed it in place and even drove some heavy duty spax screws into it as.
For pricing and availability.
The one shown requires only a 1 4 inch hole.
How to install concrete wedge anchors.
Hammer the anchor into the hole in the concrete.
Insert a 3 8 inch masonry drill bit into a hammer drill.
Drop in the anchor and hammer on the pin to expand the bottom of the shield against the wall of the hole.
Drill through the stud to make a divot on the concrete.
Tapcon 10 pack 4 in x 3 8 in concrete anchors.