The track acts as a guide for the door and also allows roller wheels to help the door run smoothly.
How to adjust sliding glass door track.
The best time to be sure a sliding patio door is properly adjusted is before it starts sticking in its track or hopping out of it.
You can alter the height of these rollers by accessing the adjustment screws which are set into slots on the door s outer edges perpendicular with the rollers themselves.
Over time the sliding glass door track accumulates dirt and grime.
All it takes is a few turns of the adjusting screw on the edge of the bottom rail of the door.
You may also want to check out our step by step guide to adjusting your sliding doors.
Standard sliding glass doors all have tracks.
Use the tension screws as needed to fine tune the adjustment.
Spray the entire sliding glass door track with a silicone based lubricant to ensure your door glides smoothly.
Read on to learn how to adjust your sliding glass door.
First locate the screws on the bottom of your sliding glass doors.
Locate the adjustment screws on the lower edges of the door.
Maintaining sliding closet doors sliding closet doors operate on rollers that are positioned in tracks at the top jamb and floor allowing the doors to bypass each other in the tracks.
Most sliding glass doors contain two sets of rollers one on each side of the bottom of the door.
A dragging shower or bathtub door can permanently damage both the door and the track if ignored for too long.
Be sure to wipe up any excess that gets on the floor it can make the floor very slippery adjusting the height.
Afterward position the door on the lower track.
Slide the door back and forth a few times to make sure all the wheels are rolling.
Make sure the rollers at the top are aligned first then walk the bottom of the door.
They may be covered by plug covers.
Clean the sliding glass door track.
Keep adjusting the tension screws until the door s latch aligns with the strike on the frame.
Most sliding doors manage to get knocked off kilter at one point or another.
Doors that are too tight can get stuck on the bottom track and there s nothing more frustrating than a sliding door that won t properly open or close.
Keep the track clean and lubricated.
Before you begin the sliding door adjustment process make sure the track is clean.
Unscrew the guide at the lower edge of the sliding door.
After a bit of adjustment the door should roll easily without rubbing on the bottom track.
This slows down your door considerably.