Honda Door Lock Actuator Screws Stuck

A rod connects the actuator to the latch and another rod connects the latch to the knob that sticks up out of the top of the door.

Honda door lock actuator screws stuck.

Average repair cost is 610 at 84 500 miles. The 2010 honda cr v has 4 problems reported for door lock actuators failed. Unclip the broken actuator from the locking assembly. Observe the plastic tab above and beneath this screw.

If you are having problems with your door locks this is the video for you make sure to watch until then. Car door lock actuators are designed to lock and unlock a door without the effort of pulling on a cable and rod. Remove this screw and unhook the tabs holding the black plastic housing for the actuator. Remove the single screw in the middle of the gold plate taking care to note the position orientation of the small locking lever.

Unclip and remove the inside door handle rod can t remember if i did this before or after unscrewing the locking mechanism. Install the lock subassembly onto the new door lock actuator using the new screws from the kit p n 72116 swa a01 and p n 72116 swa 003. There is many helpful tips and tricks to aid you in. The latch assembly gets corroded and when the pull lever cannot return fully to the rest position the latch assembly will not operate.

Make sure the open link tab fits into the open link slot. In some cars the door lock actuator is positioned below the latch. The lock actuator is behind this screw. Just unhook and slide through the holes on the metal.